Start Up - Hessaire H Serie Instrucciones De Instalación

Electrical Check Prior To Start Up:
Confirm all electrical wiring is done in accordance with all national and local codes, and also according to wiring
diagrams in this manual and those located on the units.
Before test run, check for grounding resistance using a resistance tester. Grounding resistance must be less
than 4 Ω.
During test run, use a multimeter to perform and electrical leakage test. If electrical leakage is detected, turn off
unit, disconnect all power going to unit and immediately call an electrician to resolve the cause of the leakage.
Gas Leak Check Prior To Start Up:
Using a soft brush, apply soapy water to all pipe connection points.
The presence of bubbles will alert you to a leak.
Installation Wrap Up:
Wrap line set, communication wire from indoor unit and drain tubing together using provided vinyl tape.
Ensure electrical box access covers and valve access covers are in place.
Proceed to general start up checklist and procedures.
Before Test Run:
Confirm electrical system is safe and operating properly.
Make sure unit is properly grounded.
Make sure electrical and valve access covers are securely in place.
Check all gas connections and confirm there are no leaks.
Confirm both valves are fully open.
Test Run Instructions:
1. Connect power to unit.
2. Allow a minute for unit to turn on when starting for the very first time.
3. Press on/off button on remote controller to turn indoor unit on.
(Note: There will be an initial delay for a few moments when turning on for the first time.)
4. Select the mode button and select both heating and cooling functions to confirm all functions work.
5. Check all louver and fan speed functions.
6. Ensure water drains from outside drain tube in cooling mode.
For questions pertaining to detailed remote control functions, WiFi set up or maintenance & troubleshooting, refer
to User Manual, Remote Control Manual or WiFi set up instructions sheet.
This information and more is also available online at www.hessaire.com.
Electrical & Gas Safety Checks: 7.0
Operation: 8.0 Start Up
14
Skill Level
3
Skill Level
1
Skill Level
1
Skill Level
1