General Safety Precautions: 2.0 - Hessaire H Serie Instrucciones De Instalación

General Safety Precautions: 2.0

Read Before Installation. Incorrect installation may cause serious damage or injury.
Risk of electrical shock can cause injury or death. Disconnect all remote electric power supplies before
servicing and installing.
The appliance shall be installed in accordance with the local electrical safety regulations and National Electrical
Codes (NEC).
Unit must be properly grounded during installation to avoid electrical shock.
Power supply to the outdoor unit must be an independent, dedicated, grounded circuit. Insufficient electrical
capacity can cause electrical shock or fire.
Ensure proper gauge of wire is used based on rated current.
Do not modify length of power supply cord or use and extension cord with the unit.
If the supply cord is damaged, it must be replaced by the manufacturer, a service agent, or similarly qualified
persons in order to avoid a hazard.
Do not install the unit near combustible materials or in a location exposed to combustible gases.
It is recommended that the length of the copper lines between the indoor unit and outdoor unit is less than 7.5
meters (24.6 ft). The efficiencies of the air conditioner will be negatively impacted if the length of the lines
exceeds that distance.
It is recommended that adults operate this appliance. Children should be supervised when operating or learning
to use this appliance.
Install drain tubing according to instructions in this manual. Improper drainage can damage your property.
It is not recommended to install air conditioner in damp locations such as laundry rooms or bathrooms as too
much exposure to water may cause electrical components to short circuit.
When charging refrigerant into system, make sure to charge in liquid state if the refrigerant of the appliance is
R410A. Otherwise, the chemical composition of refrigerant (R410A) may change and adversely affect the
performance of the air conditioner.
The temperature of the refrigerant circuit will be high. Please keep the interconnection cable away from the
copper tube.
Use only factory provided or approved parts and accessories during installation and/or repair.
Install unit in a location that is secure and will support the weight of the unit.
3