Machine Information; Technical Specifications - VONROC DS501AC Traducción Del Manual Original

ported or fixed.
• Only use sanding paper that is suitable for use
with the machine.
• Only use sanding paper with the correct
dimensions. Make sure that the sanding paper
is properly mounted.
• Inspect the sanding paper before each use.
Do not use sanding paper that is worn because
of prolonged use.
• Never put the machine down on a table or a
workbench before it has been switched off.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate label.
• Do not use the machine if the mains cable or the
mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
The machine is designed for sanding walls and
ceilings, for sanding smoothed drywalls, for removing
paint, wallpaper and adhesive remnants. It is not
permitted to use cutting-off wheels, roughing wheels,
fan-like grinding wheels or wire brushes. The machine
is not suitable for processing objects containing
asbestos. Improper use may damage the tool.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power input
No-load speed
Sanding pad diameter
Sanding paper diameter
Weight
Sound pressure level L
PA
Acoustic power level L
WA
Vibration
WWW.VONROC.COM
DS501AC
230-240V ~
50 Hz
750W
1500-2700/min
Ø 175 mm
Ø 180 mm
2.2 kg
74+3 dB(A)
85+3 dB(A)
3.84+1.5 m/s
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
Fig. A
1. On/off switch
2. Rear handle
3. Lock-on button
4. Speed adjustment wheel
5. Side handle
6. Dust extraction port
7. Suction power adjustment wheel
8. Side handle connection point
9. Removable front lid
10. Sanding pad cover
11. Sanding pad
12. Sanding paper
13. Dust hose
14. Hex key holder
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Mounting the side handle (Fig. A)
• The side handle (5) can be screwed into one of
the two side handle connection points (8).
EN
5