US Blaster USB 1380 Instrucciones Para El Manejo página 17

All manuals and user guides at all-guides.com
NEVER operate the amplifier without the proper power and ground wire 10 gauge minimum.
NEVER operate the amplifier without proper fusing. Fuse holder must be located with in
0.5meters from the battery. This fuse is to protect the car not the electronics. In case of a
short, the fuse will blow instead of the wire burning up. Using other than the recommended
fuse ratings at the battery and at the amplifier may cause damage to the amplifier and will
void your warranty.
Do not run wiring underneath or outside the car since exposure to the elements may cause
the insulation to deteriorate rapidly, resulting in short-circuits and/or intermittent operation.
All cables should be run beneath carpets and inside trim pieces.
To help minimize interference, it is best to run the power cables along the opposite side from
the audio cables.
Whenever wires pass through metal, rubber or plastic grommets must be used to prevent the
mental from wearing through the installation and causing a short.
Whenever possible, use cable ties, mounting clamps and similar wiring aids. (available from
an electrical supply or auto parts store) Adding stress relief loops to wiring is also advisable
to prevent straining or breakage.
It is best to test the system before the amplifier is mounted and interior of car is
reassembled.
If the temperature inside your car reaches extreme levels(such as sitting locked up for
several hours in the hot sun or exposed to a very cold winter's day)the amplifier may go
into protection mode and shut off. Leave the unit off until the ambient temperature returns
to normal.
The amplifier operates with any vehicle using a 12 volt negative ground system. If you are
not sure of the type of electrical system in your vehicle, consult your authorized dealer or
qualified mechanic.
NEVER ground the speaker leads and NEVER allow the speaker leads to come in contact
whit each other. Speaker wire should be 18 gauge or larger.
Remote turn on wire must be switched by the radio does not have a remote turn on or
antenna output, connect to wire that has a positive 12 volts when the key is turned to the
accessory. If the amplifier does not turn off the battery will die.
Do not listen to high volumes for extended periods of time or hearing damage may occur.
CONTINOUS EXPOSURE TO SOUND PRESSURE LEVELS OVER 100dB
MAY CAUSE PERMANENT HEARING LOSS. HIGH POWERED AUTOSOUND
SYSTEM MAY PRODUCE SOUND PRESSURE LEVELS WELL OVER
130dB. USE COMMON SENSE AND PRACTICE SAFE SOUND.
2