ico ICO001 Manual Del Usuario página 8

English
If you cannot safely relieve your dispenser's pressure in this way, DO NOT attempt
to open the dispenser.
Problem: The content cannot be dispensed/content sputter from the tip.
Solution: There is likely a blockage caused by undissolved ingredients, sugar, fruit
pulp or cores/seeds. Release the pressure in your dispenser, and then thoroughly
clean your dispenser before attempting to use it again. DO NOT attempt to open
the dispenser without first releasing the pressure on the device. If you cannot
safely release the pressure on the device, contact ICO Customer Service to
arrange repairs on your device.
Problem: The dispensed content is too runny
Solution One: The device has likely been overfilled. Release the pressure in the
dispenser, and pour out the excess content. You may now re-charge and use the
dispenser.
Solution Two: The preparation used does not have a high enough fat content.
Cream used in your dispenser must have a minimum fat content of 30%.
Problem: The cream charger has not been pierced.
Solution One: The charger was inserted incorrectly. Removed the chargers and try
again, following the steps in the instruction manual closely.
Solution Two: The piercing needle has been damaged. Contact your ICO
representative at www.icotrading.com
Problem: It is difficult to screw on the charger holder.
Solution: There is too much resistance between the threads of the charger holder
and the piercing needle. Remove the charger holder and oil it with a common
kitchen oil like sunflower oil or olive oil. Remember to regularly oil the thread to
prevent too much friction.
Problem: Gas escapes through the valve or decorator tip during charging.
Solution One: The device was charged without the decorator tip attached. Ensure
that the decorator tip is screwed onto the valve before attaching the charger.
Solution Two: The dispensing O-ring contains residue. Release the pressure on your
dispenser and cleaning the device before using again.
Solution Three: One or more of the silicon gaskets on the device have been
damaged. Release the pressure on your dispenser and contact your ICO
representative at www.icotrading.com.
Problem: Gas escapes between the bottle and the head during the charging
process
Solution One: There is no head gasket present. Release the pressure on your device,
insert the required gasket, and re-charge your dispenser.
8