Elettro SYNERGIC HI-MIG 3000 Manual De Instrucciones página 10


Post Gas
The adjustment can vary from 0 to 25 seconds.
To access this function, simply highlight it using the knob A
and press it for less than 2 seconds. The display screen B
shows the adjustment bar. The figure can be changed and
confirmed by pressing the knob A for less than 2 seconds.

Water unit (only for items 284.A46 and 285).
This function allows the setting of the cooling unit start-up.
The possible selections are: OFF – ON – AUTO, the
default selection is OFF. If "AUTO" is selected, when the
machine is switched on, the cooling unit starts, if the torch
trigger is not pressed after 30 seconds, it shuts off. By
pressing the torch trigger the group starts again and shuts
off 3 minutes after releasing the trigger.

LCD Contrast
The adjustment may range from 0 to 100%.
This function can be used to increase or decrease the
brightness of display screen B.
To access this function, simply highlight it using the knob A
and press it for less than 2 seconds. The display screen B
shows the adjustment bar. The figure can be changed and
confirmed by pressing the knob A for less than 2 seconds.

Options LOCK
To access this function, simply highlight it using the knob A
and press it for less than 2 seconds. The display screen B
will show a serial number SN and 8 zeros.
The purpose of this function is to unlock all the synergic
curves of the pulsed process.
To unlock the curves, instead of the zeros, an
alphanumeric code must be entered. This must be
requested from your dealer.
Once the code has been obtained, simply enter it in place
of the zeros: each letter or figure entered must be
confirmed by briefly pressing the knob A. After entering the
code, by pressing the knob A for more than 2 seconds, all
the Pulsed process curves are unlocked and the display
screen B shows UNLOCK alongside the Options function.

Factory OFF
The purpose is to return the welding machine to the
original default settings.
To access the function, simply highlight it using the knob
A. By pressing this for less than 2 seconds, the display
All manuals and user guides at all-guides.com
10
screen B shows the words OFF and ALL. By highlighting
the word ALL and briefly pressing the knob A reset is
made and the display screen B shows Factory Done!!
This indicates the reset has been successful. To return to
the previous display page, simply press the knob A for
more than 2 seconds.
NOTE. For all the functions adjusted by means of the
adjustment bar, the initial default value can be reset.
This operation be performed by pressing the knob A for more
than 2 seconds only once the adjustment bar appears on the
display screen B.
(Arc Length - Spot Time - Pause Time - Inductance, Burnback
– Soft Start - Pre Gas - Post Gas - LCD Contrast).
7 MAINTENANCE
Periodically make sure that the welding machine and all
connections are in good condition to ensure operator safety.
After making a repair, be careful to arrange the wiring in such
a way that the parts connected to the power supply are safely
insulated from the parts connected to the welding circuit. Do
not allow wires to come into contact with moving parts or
those that heat up during operation. Mount the clips as on the
original machine to avoid, if a conductor accidentally breaks or
disconnects itself, the occurrence of a connection between
power supply and the welding circuits.