Publicidad
Idiomas disponibles
Idiomas disponibles
MKC-8908
HOT AIR SMD REWORK STATION
1. Product information
1.1 Specifications
Rated power input: 300W
Rated voltage range: AC 220-240V, 50Hz
Hot Air Temperature: 100-500℃
Display: LED Segment Displays
1.2 Features
*
With a wide range adjustments for the air flow rate and temperature and various nozzles for your selection, this tool can be
used on most SMD rework job, like SOIC, CHIP, QFP, PLCC, BGA, etc.
*
Prevent PCB from the damage of electric static and electric leakage.
*
No need touch the PCB, no heating impact to the user.
*
With LED Segment Displays
2. Operating Instructions
2.1 Before Operation
*
Select the appropriate FP Pick-up Wire that matches the size of the IC.
*
Select the appropriate Nozzle that matches the size of the IC.
*
Insert the Nozzle into the top.
2.2 The display and temperature setting
1. Press the button "+" or "-" to adjust the temperature. In short press, the set-point will change ±1°C in long press, the set-
*
point will change quickly and reach your target temperature.
2."*" is the transfer button between °C/°F the default unit is °C, press the "*" button to make change between °C and °F.
*
*
3. This item has sleep function. When you put the air pump on the racket, the item will stop heating, and the display shows
"SLP"( means SLEEP), when you pick up the air pump, the item will get back to the set temperature.
2.3 QFP Desoldering
*
Before use, please check if the product voltage conforms with the local voltage.
*
Connect the mains plug to a socket.
*
Assemble the nozzles into the position( try to use nozzles with bigger diameter)
*
Turn on the power switch, set the air flow rate and temperature, and put the unit on the racket.
*
Put the nozzle on the pins of the IC( do not touch directly), so that the hot air can melt the Solder tin on the IC pin, and then
use the tweezers to remove the IC
After operation, turn off the power switch, then pull out the power plug and put the unit in a safe place out the reach of children.
Publicidad
