Technical Data; Operation Mode - Sirius SLT955 Instrucciones Para La Instalación, Uso Y Mantenimiento

OPERATION
RC001
SERIES
R C
ADIO
ONTROL
Radio control used for the remote operation
of ducted cooker hoods.

TECHNICAL DATA

- Alkaline battery powered: 12 V mod. 23 A
- Operating frequency: 433.92 Mhz
- Combinations: 32.768
- Max. consumption: 25 mA
- Operating temperature: -20 ÷ + 55 °C
- Dimensions: 120 x 45 x 15 mm.
OPERATING DESCRIPTION
The transmitter is equipped with 5 buttons
for cooker hood management, as specified
below:
: Light ON/OFF command.
: Motor ON (speed level 1) / OFF command.
: Reduce speed.
: Increase speed.
: 10-minute timer.
The set suction speed is indicated by the LED
in the suction perimeter channel.
To each color generated by the LED, it cor-
responds a specific speed, as shown below:
First speed WHITE
Second speed BLUE
Third speed DARK BLUE
Fourth speed RED
INITIAL OPERATING CONDITION
The manufacturer supplies the radio control
unit ready to be used with codes preset in the
Factory

OPERATION MODE

Standard configuration:
Default configuration requires all "cooker ho-
ods – radio control "systems to be provi-
ded with the same transmission code. If two
"cooker hood – radio control " systems are
installed either in the same room or nearby ,
it is possible that one system may affect the
operation of the other, both having the same
code. In this case, the code of one radio con-
trol system shall be changed.
Generatiing a new transmiission code:
The radio control system is provided with
factory - preset codes. Should new codes be
required, please proceed as follows: push
buttons:
simultaneously for 2 seconds: the Led lights
will turn on; then push buttons:
(within 5 seconds). 3 flashings of the Led
lights will mean that the procedure has been
completed.
WARNING! This operation will delete any
preset codes permanently.
Learniing the new transmission code:
Learning the new transmission code. After
changing the transmission code in the radio
control unit, the electronic central unit of the
cooker hood must 'learn' the new code in the
following way:
push the main power-off button of the hood
and then restore power to the electronic con-
trol unit. Push the Light Button
within the next 15 seconds, in order to syn-
chronize the electronic control unit with the
new code.
Reset of the Factory confiiguration:
If you wish to reset the default configuration,
please follow the procedure described below:
push buttons:
simultaneously for 2 seconds: the Led lights
will turn on; then push buttons:
15