Maintenance - Sirius SLT955 Instrucciones Para La Instalación, Uso Y Mantenimiento

MAINTENANCE

MAINTENANCE
An accurate maintenance guarantees good An accurate maintenance guarantees good
functioning and long-lasting performance. Spe- functioning and long-lasting performance. Spe-
cial care needs to be taken with the grease filter: cial care needs to be taken with the grease filter:
to access the filter, proceed as described in the to access the filter, proceed as described in the
PANEL OPENING chapter. PANEL OPENING chapter.
Remove the grease filter, using the special han- Remove the grease filter, using the special han-
dle. To refit the grease filter after cleaning, dle. To refit the grease filter after cleaning,
carry out the same operation in reverse order. carry out the same operation in reverse order.
To remove the carbon filter, if fitted, follow the To remove the carbon filter, if fitted, follow the
same steps as for the grease filter. The carbon same steps as for the grease filter. The carbon
filter is located immediately above the grease filter is located immediately above the grease
filter. filter.
Tepid water and neutral detergents are recom- Tepid water and neutral detergents are recom-
mended to clean the appliance, while abrasive mended to clean the appliance, while abrasive
products should be avoided. products should be avoided.
PANEL REPLACEMENT PANEL REPLACEMENT
The panel replacement is done by first open- The panel replacement is done by first open-
ing it as indicated in chapter opening panel; ing it as indicated in chapter opening panel;
in the case of the LIGHT panel, you must dis- in the case of the LIGHT panel, you must dis-
connect the power from the mains and un- connect the power from the mains and un-
plug the power cord of the lamps by acting on plug the power cord of the lamps by acting on
the electrical connector located right above the electrical connector located right above
the panel. the panel.
Remove the two locknuts securing the panel Remove the two locknuts securing the panel
(see fig. 10) and slide the panel to the right to (see fig. 10) and slide the panel to the right to
remove it from its seat. remove it from its seat.
To place the panel back into position, follow To place the panel back into position, follow
the above described procedure in reverse or- the above described procedure in reverse or-
der. der.
REPLACING LAMPS REPLACING LAMPS
To replace the damaged fluorescent lamps To replace the damaged fluorescent lamps
you must unplug the product from the mains, you must unplug the product from the mains,
then open the panel by following the instruc- then open the panel by following the instruc-
tions in the chapter "PANEL OPENING". tions in the chapter "PANEL OPENING".
Remove the six perimeter screws of the panel Remove the six perimeter screws of the panel
and open it as shown in figure 11; proceed in and open it as shown in figure 11; proceed in
replacing the fluorescent lamp using a lamp replacing the fluorescent lamp using a lamp
with the same characteristics. with the same characteristics.
Put back into position the panel and the Put back into position the panel and the
screws you previously removed. screws you previously removed.
For the replacement of the fluorescent lamps For the replacement of the fluorescent lamps
feeder, act in the same way as described feeder, act in the same way as described
above, since the feeder is positioned next to above, since the feeder is positioned next to
the lamps. the lamps.
15
17 17
17