Remote Control; Control Panel - BoomToneDJ BOOMASTER400 Manual De Uso

Altavoz activo tipo columna con led 2 x 10” 400w
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but
deposited in separate collection points for recycling.
ATTENTION
Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type. Keep new and old batteries out of
the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or
corrosion.
WARNING
The supplied remote control contains a battery. In case of ingestion, it might cause serious internal burns within
only 2 hours that might lead to death.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body,
contact immediately a doctor.
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
Accordance with the requirements of CE standard
Recycled products can be recycled
The product is suitable for indoor use

REMOTE CONTROL

1. Standby
2. Mute
3.
Repeat key (single repeat, repeat all) in USB/TF mode
4.
Mode key (Choose from AUX/USB/TF/BLUETOOTH).
Long press to switch the LEDs on the woofer on or off.
5. 0 – 9 keys
6. Sound EQ mode key (To select from Rock, Pop, Jazz, Norm,...)
7. Play / Pause
8. Volume –
9. Volume +
10. Previous Track
11. Next Track
12. Stop

CONTROL PANEL

1. Echo > to add echo effect on microphone sound
2. Treble > to increase or decrease high frequency
3. Bass > to increase or decrease low frequency
4. Microphone input 1 (6.35mm jack)
5. Microphone input 2 (6.35mm jack)
6. USB / TF input
7. Microphone Volume > to adjust the voulume of MIC 1 and MIC 2
8. REC > to record sound of MIC1 and MIC2 on USB drive
9. REPEAT > to repeat One track or all track (USB mode)
10. MODE > to switch between USB-TF/ BLUE / LINE-IN

Publicidad

Tabla de contenido
loading

Tabla de contenido