How To Adjust Air Direction - Toshiba TCB-AX21U-E Manual Del Propietário

HOW TO ADJUST AIR DIRECTION

• Never move the flap (Air direction up/down adjusting plate) which is operated on the remote
controller with hands except a case of cleaning of the flap.
• While the unit stops, the flap (Air direction up/down adjusting plate) directs downward auto-
matically.
• During preparation of heating, the flap (Air direction up/down adjusting plate) directs upward.
The swinging operation starts after heating preparation status has been cleared. However,
swinging is displayed on the AUTO flap display of the remote controller even if the heating
operation is being prepared.
How to set up the air direction
Every pushing button during operation, the air direction changes.
How to start swinging
When pushing button, set the direction of the flap (Air direction up/down adjusting plate) to
the lowest position, and then push
automatically changes upward/downward.
How to stop swinging
Pushing button once again during swinging of the flap stops the flap at the desired position.
Then, when pushing
position.
• In cooling or dry operation, the flap does not stop when the flap directs downward.
If doing so, the flap stops at the 3
In heating operation
Direct the flap (Air direction up/down adjusting plate) down-
ward, otherwise the hot air may not reach at the foot.
In cooling/dry operation
Direct the flap (Air direction up/down adjusting plate) upward,
otherwise dewdrops may adhere or drip down to near of the
discharge grille.
In air
blowing operation
Display when swinging stopped
All manuals and user guides at all-guides.com
button again, the swinging is displayed and the air direction
button, the air direction can be set to position from the uppermost
rd
position from the uppermost position.
Initial setup
9
In all
operation modes
Fan/Heat operation
Initial setup
Initial setup
Series of
operation
Cool/Dry operation