Denios GS 155 Manual Del Usuario página 12

Gas cylinder cabinet without base GS 155
(Also see overview diagram of the cabinet (Assembly GS 155-B) S. 7 and parts list p. 10)
Put the side frames (1) up, aligned at diagonal right angles as shown in Fig. 10 „securing the base to the
1.
floor, GS 155 without base".
Screw (29) the side frames (1) to the floor (see Fig. 2 „securing the base to the floor").
2.
3. Screw the rear panel (7) to the side frames (1) using hexagonal screws (22, 23, 24).
4. Screw the front roof brace (4) to the side frames using hexagonal screws (22, 23, 24), (see Fig. 5
„assembling the front roof brace"). Place the roof (14) on top of the container (ensure that it overhangs by
approx. 500 mm at the front and 50 mm at the back) and screw it to the front roof brace and the rear panel
using drilling screws. Secure the U channel (14.1) to the front edge of the roof using drilling screws(15).
5. Secure the bottom of the hinge (11) to the side frames using hexagonal screws (22, 23, 24), (see Fig. 6
„hinges").
6. Place the mortise lock (16) on door 2 and screw it in place using self-tapping screws (20). If the door opens
on the left, the lock needs to be rotated: remove the Phillips head screws from the back of the lock, remove
the front of the lock and rotate it by 180° and screw the screws back into the back of the lock.
7. Put the profile half cylinder (17) on the lock, then add on the protective plate (19), plastic plugs (21) and
the door handle (18). Secure the protective plate in place using sunken head screws (20) (see Fig. 7
„lock").
8. Assembling the door: tap the steel pin (13) into the top part of the hinge on door 2 and hang the door on the
container. Tap the smaller pin (12) into the bottom of the hinge. Align the door, adjust the screws in the
hinges or, if necessary, push the side frames lightly.
9. Put the grid supports (51) and the grid (50) in place.
10. Tighten all screws, if necessary.
11. Stick the following signs on a board (47) on the door, „smoking and open flame prohibited, and no access
to unauthorised personnel" (45 and 46).
12. If the gas cylinders are going to be stored without gas cylinder pallets, the gas cylinder holder (8) must be
secured to the rear panel using hexagonal screws (23, 24, 25) (see Fig. 9 gas cylinder holder). The support
for the gas cylinder holder (10) should be placed under the seam in the rear panel and screwed to the holder
(8) using hexagonal screws (23, 26). The securing chain (28) should be fastened to S hooks (27) pushed
through drill holes in the gas bottle holder and hung on the mesh side panels.
Gasflaschenschrank GS 155-B / GS 155
115859 / 115863
All manuals and user guides at all-guides.com
Seite 12 von 24 Seiten Ausgabe 07/2015