Single Distance Measurement; Continuous Measurement, Max And Min Measurement; Adding/Subtracting Measurements; Area Measurement - RIDGID micro LM-400 Manual Del Operario

All manuals and user guides at all-guides.com
micro LM-400 Laser Distance Meter
Do not aim the laser at the sun. This can damage the meter.
NOTICE

Single Distance Measurement

1. Press ON/Measurement Button (
symbol ( ) flashes on the screen and a beep sounds.
2. Press ON/Measurement Button again to take a measurement. You may ob-
serve a slight delay and a clicking noise when making a measurement – this
is normal.
3. The measured value is displayed.

Continuous Measurement, Max and Min Measurement

1. Press and Hold ON/Measurement Button (
( ) appears permanently on the screen and a beep sounds. Every further
press of the button gives a measurement.
2. Press and Hold either ON/Measurement Button or Clear/OFF Button (
stop continuous laser. The laser automatically switches OFF after 3 minutes
of inactivity.
3. Press the Max-Min Button (
( ) appears on screen.
4. In continuous measurement mode, the measured value is updated approxi-
mately every 0.5 seconds in the third line. The corresponding minimum and
maximum values are displayed dynamically in the first and second line.
MIN
Figure 7 – Max and Min Measurement
5. Press either ON/Measurement Button (
continuous measurement. The device automatically stops after 100 continu-
ous measurements.

Adding/Subtracting Measurements

1. Press Addition Button (
2. Press Subtraction Button (
vious one.
3. Press Clear/OFF Button (
4. Press the Max-Min Button (

Area Measurement

1. Press Area/Volume Button (
2. Press ON/Measurement Button to take the first measurement (e.g. length).
3. Press ON/Measurement Button again to take the second measurement (e.g.
width).
4. The result of the area calculation is displayed in the summary line.

Volume Measurement

1. Press Area/Volume button (
display.
) to activate the laser. The laser active
) until the laser active symbol
) until the Max and Min Measurement symbol
MAX
) or Clear/OFF Button (
) to add the next measurement to the previous one.
) to subtract the next measurement from the pre-
) to cancel the last action.
) to return to taking single measurements.
). The symbol ( ) appears in the display.
) twice until the (
) to
) to stop
) symbol appears in the
11