Stake Out Measurement; Cleaning; Storage - RIDGID micro LM-400 Manual Del Operario

All manuals and user guides at all-guides.com
micro LM-400 Laser Distance Meter

Stake Out Measurement

Two different distances (a and b) can be entered into the instrument and can then
be used to mark off defined measured lengths, e.g. in the construction of wall
studs.
b
Figure 16 – Stake out Measurement
1. Press the Angle/Stake Out Button (
bol ( ) appears in the display. The value (a) and the corresponding interme-
diate line flash.
2. By using ( ) and (
out distance. Holding down the buttons increases the rate of change of the val-
ues.
3. Once the desired value (a) has been reached, it can be confirmed with the
( ) button.
4. The value (b) and the intermediate line flashes. Value (b) can be entered using
( ) and ( ). The defined value (b) is confirmed with the (
5. Pressing the ON/Measurement Button (
The display shows current measuring distance in the summary line. Moving
slowly along the stake out line the display distance decreases. The instrument
starts to beep at a distance of 0.1 m from the next stake out point.
6. The arrows ( ) in the display indicate in which direction the instrument
needs to be moved in order to achieve the defined distance (either a or b). As
soon as the stake out point is reached the beep changes and the intermedi-
ate line starts to flash.

Cleaning

Do not immerse the RIDGID micro LM-400 Laser Distance Meter in water. Wipe
off dirt with a damp soft cloth. Do not use aggressive cleaning agents or solvents.
Gently clean the display screen with a clean dry cloth. Avoid rubbing too hard.
Treat the instrument as you would a telescope or camera.

Storage

The RIDGID micro LM-400 Laser Distance Meter must be stored in a dry secure
area between 14°F (-10°C) and 140°F (60°C) and humidity less than 70% RH.
Store the tool in a locked area out of the reach of children and people unfamiliar
with the instrument.
Remove the batteries before any long period of storage or shipping to avoid bat-
tery leakage.
The tool should be protected against hard impacts, moisture and humidity, dust
and dirt, extreme high and low temperatures and chemical solutions and vapors.
16
a
b
) longer and the stake out function sym-
), the value can be adjusted to suit the desired stake
) starts the laser measurement.
a
b
b
) button.