Using The Wall-Mounted Door Control; To Open The Door Manually; Disconnect The Trolley; To Re-Connect The Trolley - Craftsman 139.53975SRT1 Manual Del Propietário

Using the Wall-Mounted
Door Control
THE PREMIUM CONTROL CONSOLE
Light feature
Press the Light button to turn
the opener light on or off. It will
not control the opener lights
when the door is in motion. If
you turn it on and then activate
the opener, the light will remain
on for 4-1/2 minutes. Press
again to turn it off sooner.
Lock feature
Designed to prevent operation of the door from hand-
held remote controls. However, the door will open
and close from the Door Control, the Outdoor Key
Switch and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2
seconds. The push button light will flash as long as
the Lock feature is on.
To turn off, press and hold the Lock button again for
2 seconds. The push button light will stop flashing.
The Lock feature will also turn off whenever the SRT
(Smart Receiver/Transmitter) button on the motor unit
panel is activated.
Additional feature when used with the 3-function
hand-held remote
To control the opener lights:
In addition to operating the door, you
may program the remote to operate
the lights.
1. With the door closed, press and
hold a small remote button that you want to control
the light.
2. Press and hold the Light button on the Premium
Control Console.
3. While holding the Light button, press and hold the
Lock button on the door control.
4. After the opener lights flash, release all buttons.

To Open the Door Manually

• To prevent possible SERIOUS INJURY or DEATH from
LIGHTED
PUSH BUTTON
a falling garage door:
– If possible, use emergency release handle to
disengage trolley ONLY when garage door is
LIGHT
CLOSED. Weak or broken springs or unbalanced
BUTTON
door could result in an open door falling rapidly
LOCK
BUTTON and/or unexpectedly.
– NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVER use handle to pull door open or closed. If rope
knot becomes untied, you could fall.

DISCONNECT THE TROLLEY:

The door should be fully closed
if possible. Pull down on the
emergency release handle (so
that the trolley release arm
snaps into a vertical position)
and lift the door manually. The
lockout feature prevents the
trolley from reconnecting
automatically, and the door can
be raised and lowered manually
as often as necessary.

TO RE-CONNECT THE TROLLEY:

Pull the emergency release
handle toward the opener at
a 45° degree angle so that
the trolley release arm is
horizontal. The trolley will
reconnect on the next UP or
DOWN operation, either
manually or by using the
door control or remote.
32
WARNING
CAUTION
Trolley
Trolley
Release arm
(In Manual
Disconnect
Position)
Lockout position
(Manual disconnect)
Trolley
Emergency
Release Handle
(Pull at 45° angle)
To reconnect
Trolley
Release
Arm