HOMCOM 371-029 Manual Del Usuario página 5

Front wheel installation
Warning: If the wheel can not work properly, do not disassemble bearings by yourself
in order to avoid improper installation to result in the wheel unworkable properly.
Please contact the seller directly if you can not sort out the problem.
Please do not unscrew the two sides of nuts (c).The clearance between the bearings was
adjusted at the factory.
Install wheels with axles pushed fully into axle slots. Make sure to install tab washers (a) so that
the tab is inserted into the round hole in the frame. This washer should be on the outside of the
frame, between the frame and axle nut.
Make sure wheels are centered, tighten the axle nuts (b) firmly with a wrench .
Front fender installation
1. The front fender fixing piece is inserted into the front brake screw.
2. Insert the gasket with the concave side of the gasket backward (close to the arc of the front
fork riser when locked)