HOMCOM 371-029 Manual Del Usuario página 6

3: Insert the front brake screw into the hole of the front fork riser.
4: Sleeve the gasket with the concave side of the gasket forward (close to the arc of the front
fork riser when locked),Tighten the nut.
5: The front wheel axle is stuck in the front fork groove, then insert the safety hook.
6: Tighten the inner nut to fix the wheel.
7: Set the fender support into the front axle and tighten the outer nut to fix the fender support.
Rear wheel installation
Please do not unscrew the two sides of nuts (c).The clearance between the bearings was
adjusted at the factory.
Install wheels with axles pushed fully into axle slots. Make sure to install tab washers (a)
so that the tab is inserted into the round hole in the frame. This washer should be on the
outside of the frame, between the frame and axle nut.
Make sure wheels are centered, tighten the axle nuts (b) firmly with a wrench .