Distance Measurement; Scan Mode - Leica RANGEMASTER 900 scan Instrucciones

Distance measurement

To measure the distance to an object, it must be
perfectly targeted. To do this, activate the target
mark by pressing the release button (3) once.
The target mark remains lit for about 4 seconds
after letting go the release button. The target
mark remains permanently lit as long as the but-
ton is held down. Whilst the target mark is lit,
train the Leica Rangemaster on the object and
press the release button a second time; the
distance is then measured and displayed. The
target mark goes out briefly during the measure-
ment. A new measurement can be made at any
time, as long as the target mark is lit, by pres-
sing the release buttononce again. If the object
All manuals and user guides at all-guides.com
is less than 10m away, is out of range or does
not provide enough reflection, then "---" appears
on the display. The Leica Rangemaster switches
itself off as soon as the display disappears.

Scan mode

With the Leica Rangemaster, continuous meas-
urements can be made. If the release button (3)
is held down the second time it is pressed, after
approx. 0.5 seconds the unit switches to scan
mode, and then takes continuous measure-
ments. This is indicated by the changing display:
a new measured value is output around every
1.5 seconds.
Scan mode is particularly practical when meas-
uring to smaller targets.
Note:
Due to the constant measurements, the power
consumption is greater in scan mode than for
single measurements.
16