Connect Inlet Hoses; Clear Water Lines - Whirlpool CAE2795FQ Instrucciones De Instalación

6. For floor drain installations, you will need to remove the drain
hose form from the end of the drain hose. You may need
additional parts with separate directions. See "Tools and Parts."
7. The floor drain system requires a siphon break that may be
purchased separately. The siphon break (Part Number 285320)
must be a minimum of 28" (710 mm) from the bottom of the
washer. Additional hoses might be needed.

CONNECT INLET HOSES

Insert new hose washers (supplied) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
Washer Coupling
Connect Inlet Hoses to Water Faucets
1. Attach hose to hot water faucet. Screw on coupling until
it is seated on washer. Repeat process for cold water.
8
2. Use pliers to tighten the couplings an additional
two-thirds turn.
IMPORTANT: Do not overtighten or use tape or sealants on valve
when attaching to faucets or washer. Damage can result.
3. Secure drain hose to inlet hose with zip strap.

Clear Water Lines

Run water through both faucets and inlet hoses,
n
into a laundry tub, drainpipe, or bucket, to get
rid of particles in the water lines that might clog
the inlet valve screens.
Check the temperature of the water to make
n
sure that the hot water hose is connected to the
hot water faucet and that the cold water hose
is connected to the cold water faucet.
Connect Inlet Hoses to Washer
1. Attach cold water hose to cold water inlet valve marked
with a blue ring. Screw coupling by hand until it is snug.
2. Attach hot water hose to hot water inlet valve marked
with a red ring. Screw coupling by hand until it is snug.