Connecting The Electrical Power To Magicspeed - Dometic GROUP Waeco MagicSpeed MS-BE3 Instrucciones De Montaje Y De Uso

MagicSpeed Accessory
NOTICE!
A
Before drilling holes, make sure the drill bit will not damage any-
thing on the other side (fig. 2, page 3).
➤ Drill a 6 mm hole near the control element.
➤ Guide the cable of the control element through this hole to the cable of the
cruise control.
➤ Lay the connection cable to the cable set.
7 Connecting the electrical power to
MagicSpeed
7.1 General notes on laying cables
NOTE
I
 As far as possible, use original ducts for laying the cables, or
other suitable options, such as panelling edges, ventilation
grilles or dummy plugs. If no openings are available, you must
drill holes for the cables. Check beforehand that there is suffi-
cient space on the other side for the drill head to come out.
 Cables and connections that are not properly installed will
cause malfunctions or damage to components. Correct installa-
tion of cables and connections ensures lasting and trouble-free
operation of the retrofitted components.
Therefore, please observe the following instructions:
 To prevent damage to the cables, when laying them, ensure that they are
far enough away from hot or moving vehicle components (exhaust pipes,
drive shafts, light systems, fans, heater etc.).
 Wrap insulating tape around every connection on the cable (even inside
the vehicle).
 When laying electric connections (fig. 3, page 3), ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection
EN

Connecting the electrical power to MagicSpeed

25