General Description; Safety Instructions - Eneo VKC-1374/IR Instrucciones De Manejo E Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation and Operating Instructions
1/3" Day/Night Camera with IR Illumination
VKC-1374/IR

1. Safety Instructions

• Read these safety instructions and the operation manual first before you
install and commission the camera.
• Keep the manual in a safe place for later reference.
• P rotect your camera from contamination with water and humidity to prevent
it from permanent damage.
Never switch the camera on when it gets wet. Have it checked at an
authorized service center in this case.
• Never operate the camera outside of the specifications as this may prevent
the camera functioning.
• Do not operate the cameras beyond their specified temperature, humidity or
power ratings.
Operate the camera only at a temperature range of 0°C to +50°C and at
a humidity of max. 90%.
• To disconnect the power cord of the unit, pull it out by the plug.
Never pull the cord itself.
• P ay attention when laying the connection cable and observe that the cable
is not subject to heavy loads, kinks, or damage and no moisture can get in.
• The warranty becomes void if repairs are undertaken by unauthorized
persons. Do not open the camera housing.
• Never point the camera towards the sun with the aperture open.
This can destroy the sensor.
• Make sure the sensor is not covered !
• Installation, maintenance and repair have to be carried out only by
authorized service centers.
Before opening the cover disconnect the unit from mains input.
• The fitter is responsible for the system of protection being followed in
accordance with the technical data, e.g. by sealing of the cable outlet with
silicone.
• Contact your local dealer in case of malfunction.
• Only use original parts and original accessories from Videor E. Hartig GmbH.
• Do not use strong or abrasive detergents when cleaning the dome.
Use a dry cloth to clean the dome surface.
In case the dirt is hard to remove, use a mild detergent and wipe gently.
• During assembly, care must be taken to ensure that existing seals are
correctly inserted and are not displaced as a result of assembly.
You must not continue to use damaged seals.
NOTE: This is a class A digital device. This digital device can cause
harmful interference in a residential area;
in this case the user may be required to take appropriate
corrective action at his/her own expense.
All manuals and user guides at all-guides.com

2. General Description

• 1/3" Sony Super HAD CCD
• Removal IR Cut Filter (ICR)
• Sensitivity of 0.5Lux at F1.2 (Colour)
• Automatic Gain Control (AGC)
• Integrated DC Varifocal Lens F1.2/3.8-9.5mm
• IR Illumination by 18 integral 850nm LEDs
• Illumination Range: Approx. 20m
• Supply Voltage: 12VDC
• Protection Rating: IP65
• For Easy Indoor and Outdoor Installation
3. Installation
Ceiling Mount
Wall Mount

Publicidad

Tabla de contenido
loading

Tabla de contenido