Chicco miinimo 2 Manual Del Usuario página 5

are
Miinimo
io-
un
no IMPORTANT- KEEP THESE IN-
nte
STRUCTIONS FOR FUTURE REF-
ERENCE.
sto
WARNING: BEFORE USE, REMOVE
on
AND DISPOSE OF ALL PLASTIC
BAGS AND PACKAGING MATERIALS
AND KEEP THEM OUT OF REACH OF
er-
re.
CHILDREN.
il
WARNINGS
• WARNING: The adaptor can only
ef-
be used with the Chicco Miinimo²
Stroller.
• WARNING: The adaptor can only
on
zia
be used with the Chicco KeyFit car
ere
seat.
• WARNING: Before use, check cor-
rect fixing of the adaptor to the
ità
sto
frame of the stroller.
un-
• WARNING: Before use, make sure
a o
di
that the child car seat is fit correctly
ati-
in the adaptor by pulling it up.
te.
• When not in use, keep the adaptor
out of reach of children.
ASSEMBLING AND MOUNTING THE ADAPTOR
1. The adaptor is supplied disassembled in its 3 parts (fig. 1).
2. Please refer to the figures for assembling the parts. Insert
the tube equipped with two metal pins - located at the
ends of it - into the relevant plastic parts (fig. 2), making
sure that the metal pins are properly inserted into the
holes (fig. 2A).
3. When assembled, the adaptor is ready to be assembled
onto the stroller (fig.3).
WARNING: Before installing the adaptor on the stroller, re-
move the bumper bar.
4. For assembling the adaptor, place it on the stroller frame,
carefully inserting the clamping devices of the bumper
bar into the appropriate seats, located in the plastic parts
of the adaptor (fig. 4 - 4A). To complete the operation,
fasten the adaptor to the frame using the plastic levers
placed on each side (fig. 4B - 4C).
WARNING: Before installing the car seat, check that the adaptor
is assembled correctly (fig. 4D).
5. To install the Chicco KeyFit Car Seat, recline the stroller's
backrest and then place the car seat onto the adaptor.
Make sure you hear the double click that indicates the
proper clamping of it (fig. 5). The car seat should be fixed
only and exclusively facing parent.
Adaptor
2
6. To remove the Car Seat press the button on the back and
pull upwards (fig. 6)
WARNING: It is not possible to close the stroller when the
adaptor is mounted on the frame.
DISASSEMBLING THE ADAPTOR
7. The adaptor can be removed by moving the plastic levers
outwards (fig. 7) and by pulling the adaptor towards you.
Once the adaptor has been unhooked, the bumper bar
previously removed must be fixed back on again.
ADVICES FOR CLEANING AND MAINTENANCE
The cleaning and maintenance of the product must only
be carried out by an adult.
CLEANING
Dry the metal parts, after possible contact with water, in
order to avoid the formation of rust. Do not use solvents or
abrasive products for cleaning. After use keep the adaptor
in a dry place.
WARRANTY
The product is guaranteed against any conformity defect in
normal conditions of use as provided for by the instructions
for use. The warranty shall not therefore apply in the case
of damages caused by improper use, wear or accidental
events. For the duration of warranty on conformity defects
please refer to the specific provisions of national laws appli-
cable in the country of purchase, where provided.
5