Temperature And Adjustment; Keg Tapping And Untapping - LINDR PYGMY 20 Green Line new Instrucciones De Uso

14.2 Speed Fitting Removal
Hold the grey ring tight against the body of the speed fitting and pull out the hose.
WARNING: If you do not hold the grey ring but pull at the hose, the speed fitting will cut
even deeper into the hose.
WARNING: Hoses must not be pressurised during removal.

15. TEMPERATURE AND ADJUSTMENT

The temperature of the cooled beverage is controlled by a mechanical thermostat in
temperature range of 2 °C to 8 °C. The thermostat has a numerical scale of 1-7.
WARNING: If you are using the cooler to cool non-alcoholic beverages, set the thermostat
knob to 5 at the most, otherwise, there is a risk of the beverage freezing in the cooler's tubing
and damaging the device.

16. KEG TAPPING AND UNTAPPING

16.1 Keg Tapping
Procedure for tapping a keg using an S-system keg coupler.
16.2 Keg Untapping
Procedure for untapping a keg using an S-system keg coupler:
16.3 Keg Tapping
Procedure for tapping a keg using an A-system keg coupler:
16.4 Keg Untapping
Procedure for untapping a keg using an A-system keg coupler:
WARNING: Make sure the adapter is clean before tapping the keg!
(see Fig. 15.)
Max. Inlet beverage temperature 25 °C.
:
(see Fig. 16.)
:
EN
21