Programming Two Products - Chauvet DJ Obey 40 Manual Usuario

Programming Two
Products
Page 22 of 160
Programming products is sending DMX values to them to control them and create a look.
The general steps for programming a product are as follows:
1. Enter Program mode.
2. Press one or more <FIXTURE> buttons to select one or more products.
3. Move the channel faders to control the product or products—use <Page Select> to move
between fader pages.
4. Repeat steps 2–4 as needed for other products.
5. Save the look into a scene. See
6. Exit Program mode.
Note: If the look is not saved to a scene it will be lost when Program mode is exited.
The specific instructions below describe programming a 12-channel product on <FIXTURES 3> and
a 15-channel product on <FIXTURES 5>.
1. Enter Program mode.
2. Press <FIXTURES 3>. Its LED comes on and it is selected.
3. Move any of the 8 channel faders to send DMX values to the first 8 channels of <FIXTURES 3>.
The light responds to the faders.
4. Press <Page Select>. The Page B LED comes on and the Page A LED goes out. Fader Page B
is now active.
5. Move any of the first 4 channel faders to send DMX values to the last 4 channels of
<FIXTURES 3> and the product responds to the faders.
6. Press <FIXTURES 5>. Its LED comes on and it is selected. Now both lights are selected.
7. Press <FIXTURES 3>. Its LED goes out and it is no longer selected. Now only <FIXTURES 5> is
selected.
8. Press <Page Select>. The Page A LED comes on and the Page B LED goes out. Fader Page B
is now active.
9. Move any of the 8 faders to send DMX values to the first 8 channels of <FIXTURES5>. The light
responds to the faders.
10. Press <Page Select>. The Page B LED comes on and the Page A LED goes out. Fader Page B
is now active.
11. Move any of the first 7 faders to send DMX values to the last 7 channels of <FIXTURES 5>. The
light responds to the faders.
12. Repeat steps 2–11 as needed for other products.
13. Save the look into a scene. See
Note: If the look is not saved to a scene it will be lost when Program mode is exited.
Creating A Scene.
Creating A Scene.
Obey 40 User Manual Rev. 8