Cub Cadet Commercial 53AWEFJA603 Instrucciones De Funcionamiento Originales página 15

Assembly
Attaching the discharge flap on the cutter
deck
Remove the screws [1] and nuts [2] on the dis-
charge opening of the cutter deck.
using the screws [1] and nuts [2].
Attaching the trailer coupling (optional;
depending on the model)
Remove the trailer coupling [1] with the screws [2]
and nuts [3] on the rear panel [4] of the device.
Rotate the trailer coupling horizontally by 180°.
Fix the trailer coupling [1] with the screws [2] and
the nuts [3] to the rear panel [4] of the device.
Putting the battery into operation
DANGER !
caused by battery acid and gases emitted
by battery acid
Battery acid is corrosive. Immediately
clean all parts of the device splashed by
battery acid.
Do not smoke; keep burning and hot
objects away.
Charge batteries in a well ventilated and
dry room only.
There is a risk of a possible short circuit
when working with the battery. Do not
place any tools or metal objects on the
battery.
DANGER !
Risk of poisoning and injury from battery
acid
Wear safety goggles and protective
gloves.
Do not allow battery acid to come into
contact with skin.
If battery acid is sprayed in your face or
eyes, wash it off immediately with cold
water and seek medical attention.
If you have swallowed battery acid, drink
a lot of water and seek medical attention.
Store batteries out of the reach of
children.
Never tilt the battery, as battery acid may
run out.
Bring the remaining, unused battery acid
to your dealer or to a waste disposal
company.
769-11757
[3] to the discharge opening
Attention !
Disconnect and connect the battery in the correct
sequence.
Only operate the battery with the battery terminal
protective battery cover).
Note
The battery is situated under the passenger
seat.
the factory.
Installation
First connect the red cable (+ / positive pole)
Then connect the black cable
(- / negative pole) .
Attach the battery terminal cover.
Removal
Remove the battery terminal cover.
First disconnect the black cable (- / negative pole).
Then disconnect the red cable (+ / positive pole).
Charging the battery
WARNING !
Electrolyte liquid even discharges from
sealed batteries.
Avoid tilting the battery.
battery with a 12 Volt battery charger (maximum
charging current 6 amps) for one to two hours.
charger plug.
Then disconnect the battery (see also operating
instructions for the battery charger).
Attention !
Follow the instructions in the operating manual
for your battery charger.
EN
.
15