Starting; Advice On How To Use The Remote Control; Inserting/Replacing The Batteries; Powering The Air Conditioner - Ferroli DIAMANT Serie Manual De Instrucciones

2. STARTING

2.1 ADVICE ON HOW TO USE THE REMOTE CONTROL

Comply with the following instructions to correctly use the remote control:
1. Remove the battery if the remote control is not going to be used for a long period of time.
2. When used, direct the remote control towards the signal receiver of the interior unit (1).
3. The remote control signal is received up to a distance of 8 meters.
4. The signal must not be obstructed by any kind of object.
5. Handle the remote control with care.
6. The signal could be disturbed by a fast-acting lamp, a fluorescent lamp of the inverter type or a mobile phone.
7.
The remote control should not be left in a place where it could be exposed to direct sunlight, near a stove or another heat source.
N.B. The batteries described in point 1 must be kept in a safe place, well away from children's reach.

2.2 INSERTING/REPLACING THE BATTERIES

To insert/replace batteries, proceed as follows "fig. 3 -":
1. Remove the cover (1).
2. Remove the discharged batteries and insert the new ones
(2), making sure that they are positioned as shown in the
diagram in the battery housing.
3. Fit the cover (3) back in place.
N.B.: Remove the batteries from the remote control when the air
conditioner is not going to be used for a long period of time,
must be kept in a safe place, well away from children's reach.
To safeguard the environment and the safety of persons, always
dispose of old batteries in the specific containers.

2.3 POWERING THE AIR CONDITIONER

Press the ON/OFF button ("fig. 4 -") to power the air conditioner.
Remember that the liquid crystal display will always indicate the
last operating mode and previously used functions. Comply with
the instructions if you wish to change the operating mode of the
system.
24
EN
Cod. 3QE46160 - Rev. 00 - 11/2019
DIAMANT
fig. 3 -
fig. 4 -