Auto Mode; Adjusting The Output Air - Ferroli DIAMANT Serie Manual De Instrucciones

2.7 AUTO MODE

During the AUTO mode, the unit automatically selects HEAT, FAN, COOL based on the ambient temperature
AUTO mode activation:
First select the AUTO on the remote control using the MODE key. Then select the desired set point temperature. The mode of opera-
tion will depend on the difference, positive or negative, between the set temperature and the ambient temperature. If this difference
cannot exceed the unit is activated only in ventilation mode.
Notes to the AUTO mode
1. In "AUTO" mode, the air conditioner can automatically switch between the modes of cooling, heating and ventilation by detecting
the difference between the actual temperature and the set temperature on the remote control.
2. In "AUTO" mode, you can select the fan speed, which is adjusted automatically.
3. If you think that the "AUTO" mode does not ensure the necessary comfort, you can manually select the desired mode.

2.8 ADJUSTING THE OUTPUT AIR

When you turn the flap assumes a preset angle. It's possible to adjust automatically the vertical direction of the air while the horizontal
adjustment is necessary to intervene manually.
Vertical Adjustment
To adjust the vertical air flow direction ("fig. 7 -") of the indoor unit
press the "SWING" or "DIRECT" button.
By pressing the "SWING" button, the air flap continues to move,
mixing the air in the environment.
By pressing the "DIRECT" button, the air flap blocks and each
time the "DIRECT" button is pressed, the airflow direction is chan-
ged by an angle of 6°.
Note: in "COOL" or "DRY" operating mode, it is not recommended
to set the flap in vertical position for too long to avoid the accumu-
lation of condensate drops
In "COOL" or "HEAT" operating mode, it is not recommended to
position the flap in a vertical position as the low air flow can redu-
ce the performance of the unit.
Do not change the position of the flap manually. If this happens,
switch the unit off and switch it off for a few seconds to reset the
positioning of the deflector.
Horizontal Adjustment
To adjust the direction of the horizontal air flow ("fig. 8 -") must be
operated manually by acting on the levers of the deflector
28
EN
Cod. 3QE46160 - Rev. 00 - 11/2019
DIAMANT
fig. 7 -
fig. 8 -