Before Calling For Service - LG UPSE3024ST Manual Del Propietário

Before Calling for Service

Before you call for service, review this list. It may save you time and expense. The list includes common
occurrences that are not the result of defective workmanship or materials in this appliance.
Symptoms
• Poor installation. Place oven rack in center of oven. Place a level on the oven
• Be sure floor is level and strong and stable enough to adequately support range.
Range is not level.
• If floor is sagging or sloping, contact a carpenter to correct the situation.
• Kitchen cabinet alignment may make range appear unlevel. Be sure cabinets are
• Cabinets not square or are built in too tightly. Contact builder or installer to make
Cannot move
appliance easily.
• Carpet interferes with range. Provide sufficient space so range can be lifted over
Appliance must be
accessible for service.
• Anti-tip device engaged.
• Electronic control has detected a fault
Oven control beeps
and displays any F
code error.
• Improper cookware being used.
Surface units will not
maintain a rolling boil
or cooking is not fast
• In some areas, the power(voltage) may be low.
enough
• A fuse in your home may be blown or the circuit breaker tripped.
Surface units do not
work properly
• Cooktop controls improperly set.
Surface unit stops
glowing when
• This is normal. The unit is still on and hot.
changed to a lower
setting
• Food spillovers not cleaned before next use.
Areas of discoloration
• Hot surface on a model with a light-colored cooktop.
on the cooktop
Frequent cycling on
• This is normal.
and off of surface
units
All manuals and user guides at all-guides.com
Possible Causes / Solutions
rack. Adjust leveling legs at base of range until the oven rack is level.
square and have sufficient room for range clearance.
appliance accessible.
carpet.
condition. Turn the Oven mode knob
to the Off position to clear the display
and stop beeping. Reprogram oven.
If fault recurs, record fault number.
Turn the Oven mode knob to the Off
position and contact a Service agent.
- Use pans which are flat and match the diameter of the surface unit selected.
- Cover pan with a lid until desired heat is obtained.
- Replace the fuse or reset the circuit breaker.
- Check to see the correct control is set for the surface unit you are using.
- See Cleaning the Glass-Ceramic Cooktop section.
- This is normal. The surface may appear discolored when it is hot. This is
temporary and will disappear as the glass cools.
- The element will cycle on and off to maintain the heat setting.
TROUBLESHOOTING
CODE CAUSE
F-3 Key short error
F-9 Oven not heating
51