Selecting The Mode; Pump Operation; Care Instructions - Steinbach Classic 310 Manual Original

Selecting the mode

1. Switch the pump
power plug.
2. Press and hold down the valve lever
on the valve head
3. Turn the valve lever to the desired
position and let go.
The level engages at that position.
The desired mode is set.

Pump operation

Starting the pump operation
Check the valve setting of your filter system before you activate the pump.
1. Connect the pump's power plug to the power supply.
The pump is running. Listen to the pump to check for any unusual noises. If there is air in
the system, bleed it again.
Stopping the pump operation
Pump operation is ended by unplugging the power plug.
Pump operation with an external timer
The pump can be operated in intervals with the aid of an external timer (not included in
the package contents).
1. Connect the timer to the power supply and set the desired running times.
2. Connect the pump's power plug to the timer.
The timer now controls the running times of the pump.

Care instructions

The filter system cannot filter out algae, bacteria and other microorganisms.
- Use special water care substances to prevent and remove these to ensure
hygienically clean water.
- Consult an expert and observe the dosage.
off by pulling the
3
.
1
19
31
57