Parweld XR1052 Manual De Instrucciones página 11

XR1052 / XR939H
Wearing Position
Adjusting The Head Band
To fi t and adjust the welding helmet position on your head, fi rst place helmet over
your head.
Adjust the tightness of the headband, use the rear nut (1). Adjust until it is a good fi t
around your head.
Adjust the height at which the helmet sits on top of your head, adjusting the top
strap (2), by pressing the strap apart repositioning the clip in a new strap hole and
pressing together again.
Adjust the nose to fi lter distance on both sides of the head band, unclip the side
bracket (3), slide the head band backwards or forwards into a suitable position for
your head, then press the clips back into place to secure.
Adjust the rake angle so that the viewing window is in front of your eyes and the
base of the helmet sits close to the chest in the down position. Slacken the external
nuts on the helmet sides (4) and then move the slotted rake angle plates (5) on the
inside of the helmet. Locate the plates onto the shell tabs in the new position to set
the rake angle.
( (4 ( (4 (4 (4 (4) (4
(3)
(5)
(4)
(5)
(4)
(3)
(5)
(2 (2 (2 (2 ( 2 ( ( ( (2)
(1)
English | 11