Jocel JLR013989 Manual De Instrucciones página 55

USE PROCESS
❖ Installation place requirement
• A concrete floor is the most suitable
installation surface for a washing machine,
being far less prone to vibration during the
spin cycle than wooden floorboards or
carpeted surface.
• The machine must be level and securely
positioned. The distance between the
machine and wall must be more than 10
cm.
• To avoid vibrations during spinning. the
machine should not be installed on soft
floor coverings.
❖ Level adjustment
The machine must stand perfectly level on all four feet to ensure safe and
proper operation. Incorrect installation may cause vibrations and noise and may
cause the machine to move about.
To do these when the machine is not level:
• Using the spanner turn locknut
in a clockwise direction. Then
turn locknuts together with
adjust feet to unscrew.
• Hold adjust feet securely with
a pipe wrench.
• Turn locknut again using the
spanner until it sits firmly up
against the housing.
Note
Vibration and noise may occur if the locknuts do not sit firmly up against
the houses.
❖ Drain hose connection
1. Direct into a sink
If the outlet spigot has not been used before, remove any blanking plug that
may be in place
Push the drain hose onto the spigot and secure with a clip if required, ensure a
loop is formed in the drain hose to prevent waste from the sink entering the
washing machine.
If required, the drain hose can be extended to a length of 4 m.
55