nanny BM-02 Manual Del Usuario página 15

Ocultar thumbs Ver también para BM-02:
Tabla de contenido

Publicidad

Dystrybucja systemów Jablotron: MBS SYSTEMS s.c.
we recommend that you purchase a replacement sensor pad as the manufacturer does not guarantee
the correct functioning of the sensor pad after 2 years of use.
The manufacturer does not recommend buying or renting a second-hand product as careless han-
dling of the sensor pad by some users could result in impaired sensitivity. The manufacturer cannot be
held responsible for damage or impairment of rental or second-hand devices.
B A T T E R Y
M A I N T E N A N C E
The Nanny does not require regular maintenance however it is recommended that the Nanny is tested
weekly. To clean, use a soft damp cloth to wipe the device when necessary, aggressive cleaning fluids
should not be used. Avoid water or any other liquid getting inside the control unit or inside the sensor
pad.
Protect the sensor pad from physical damage. This includes (but not exclusively): impact
blows, dropping and bending.
1. Why did the Nanny trigger an alarm, when the baby was breathing normally and regularly?
Answer:
Movements of the baby's body during breathing were not reliably being detected by the
sensor pad.
Solution:
Babies up to 3 months of age have a low weight and do not change their position in bed, it is rec-
ommended that you place the sensor under the sheet, towel or blanket the baby lies on. This helps to
minimize false alarms. Once the infant starts to roll and crawl, place the sensor under the mattress.
If the baby has to lie on a slope, with his head higher than his body (following doctor's orders), it is
still necessary to maintain close contact between the baby, mattress and the sensor pad. Check that
the mattress lies entirely on the sensor pad with its own weight. It is better to raise the feet of the cot
rather than the mattress.
The mattress must not be firmly gripped by the sides of the bed and shouldn't be "hanging" above
the bed's base.
2. Why wasn't an alarm triggered after taking the baby out of the crib?
Answer:
A disruptive vibration was detected by the sensor pad, possibly caused by:
Are there people walking past the crib? (This is a problem particularly if the crib is on a parquet or
laminate floor) To reduce the effect of floor vibrations, place pieces of carpet under the legs of the cot
to absorb the vibration.
Is there an open window near the crib and it is windy outside. It is important to eliminate any disrup-
tive vibrations for Nanny to function properly.
If the crib is in contact with a fridge or another source of vibration it will be necessary to separate
the source of vibration.
B M- 0 2 Nan n y Bab y R espir at ion Monit or
R E P L A C E M E N T
If there is no beep sound after turning the unit on and the red indicator
flashes
then the batteries need to be replaced. Replace with 2 new AA
size alkaline batteries (polarity is clearly marked in the battery compart-
ment). Once the batteries have been replaced, switch the Nanny on and
check for the beep sound.
Note: Do not use rechargeable batteries.
F A Q
15
www.sklep-jablotron.pl
A N D
C L E A N I N G
M FV52104 N AV-032.04

Publicidad

Tabla de contenido
loading

Productos relacionados para nanny BM-02

Tabla de contenido