Setting The Force - Craftsman 139.53939D Manual Del Propietário

Ocultar thumbs Ver también para 139.53939D:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ADJUSTMENT STEP 2

Setting the Force

The force setting measures the amount of force required to
open and close the door.
1. Push the purple button twice to enter into the Force Adjustment
Mode. The LED will flash quickly.
2. Push the door control or programmed remote control. The door
will close (DOWN).
3. Push the door control or programmed remote control again.
The door will open (UP).
4. Push the door control or programmed remote control a third
time to close the door (DOWN).
The LED will stop flashing when the force has been programmed.
The door must travel through a complete cycle, up and down, in
order for the force to be set properly. If the garage door opener
cannot open and close the door fully, inspect the door to ensure
that it is balanced properly and is not sticking or binding.
If the door is not stopping exactly where you would like it,
repeat Program the Travel Limits.
Without a properly installed safety reversal system, persons
(particularly small children) could be SERIOUSLY INJURED or
KILLED by a closing garage door.
• Too much force on garage door will interfere with proper
operation of safety reversal system.
• NEVER use force adjustments to compensate for a binding or
sticking garage door.
• After ANY adjustments are made, the safety reversal system
MUST be tested. Door MUST reverse on contact with
1-1/2" (3.8 cm) high object (or 2x4 laid flat) on floor.
Figure 1
Figure 2
Push Purple button
twice to enter
unit into Force
Adjustment Mode
Figure 3
28
LED
Black Button
Purple Button
LED
Black Button
Purple Button
or

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido