Assembly; Assemble The Rail And Install The Trolley - Craftsman 139.53939D Manual Del Propietário

ASSEMBLY STEP 1

Assemble the Rail and Install the Trolley

To avoid installation difficulties, do not run the garage door
opener until instructed to do so.
The front rail has a cut out "window" at the door end. The front
and back rail both have rail tabs. These rail tabs MUST be on top
of the rail when assembled.
1. Remove the straight door arm and hanging bracket
packaged inside the front rail and set aside for Installation
Steps 5 and 12.
NOTE: To prevent INJURY while unpacking the rail carefully
remove the straight door arm stored within the rail section.
2. Align the rail sections on a flat surface as shown and slide the
tapered ends into the larger ones. Tabs along the side will lock
into place.
3. Place the motor unit on packing material to protect the cover,
and rest the back end of the rail on top. For convenience, put a
support under the front end of the rail.
Inner Trolley
Front Rail Section
(TO DOOR)
Outer Trolley
Wear Pads
Trolley
Rail Tab
Idler Pulley
Hole
Window
Cut-Out
To prevent INJURY from pinching, keep hands and fingers
away from the joints while assembling the rail.
4. As a temporary stop, insert a screwdriver into the hole
10" (25 cm) from the front end of the rail, as shown.
5. Check to be sure there are 4 plastic wear pads inside the inner
trolley. If they became loose during shipping, check all packing
material. Snap them back into position as shown.
6. Slide the trolley assembly along the rail from the back end to
the screwdriver.
7. Slide the rail onto the "U" bracket, until it reaches all the stops
on the top and sides of the "U" bracket.
"U" Bracket
SLIDE TO STOPS ON
TOP AND SIDES OF
"U" BRACKET
8
Back Rail Section
(TO MOTOR UNIT)