Panasonic TY-WK42PV7 Instrucciones De Instalación página 3

Components
Wall-hanging bracket (1)
Insulating spacer (4)
PROFESSIONAL INSTALLATION IS REQUIRED.
PANASONIC DISCLAIMS ANY PROPERTY DAMAGE AND/OR SERIOUS INJURY, INCLUDING DEATH
RESULTING FROM IMPROPER INSTALLATION OR INCORRECT HANDLING.
Points to note during installation
The wall-hanging bracket is for use in installing the Plasma Display to a vertical wall for viewing
purposes. Do not use it for any type of installation other than vertical wall installation.
In order to ensure correct, problem-free operation of the Plasma Display, do not install the Display
in any of the following places.
• Near sprinklers or fire/smoke detectors.
• Where there is a risk of exposure to vibration or impact.
• Near high-voltage wires or dynamic power supplies.
• Near sources of magnetism, heat, water vapor or soot.
• Locations exposed to air blown from heating equipment.
• Where droplets of condensation from an air conditioner or other unit may form.
When installing this wall-hanging bracket unit, use a fixing method appropriate to the type of wall.
Use commercially available screw with a nominal diameter of 6 mm that are suited to the wall
material (wood, steel frame, concrete, etc.) you are fitting the bracket to.
Insert the power cord plug for the Plasma Display into a wall outlet which is close and easily
accessible.
Provide adequate ventilation so that the temperature around the display does not rise above 40 °C
(104 °F). If there is insufficient movement of the air inside display, heat may build up inside the
display, and break down may result.
Reinforce the area of the wall where the display is to be mounted if it is not strong enough.
If the display is not mounted securely and the mounting screws should come loose, the display
may fall off the wall.
Do not mount this Plasma Display directly below ceiling lights (such as spot lights, flood lights or
halogen lights) which typically give off high heat. Doing so may warp or damage plastic cabinet parts.
Toothed pan washer (4)
Allen key (1)
Fixing screw
(For horizontal installation)
(M5 × 135) (2)
Fixing screw
(For vertical installation)
(M5 × 35) (2)
Pan head bolt with hex socket
(M8 × 45) (4)
9