Standard Accessories - HIKOKI WR 18DF Instrucciones De Manejo

NAMES OF PARTS (Fig. 1–Fig. 10)
Hammer case
Anvil
LED light
Trigger switch
Battery
Handle
Push button
Motor
Latch
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
WR18DF : Cordless Impact Wrench
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU
on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
Direct current
V Rated voltage
n
No-load speed
0
min Oscillation per minute
-1
Bpm Impact rate
Ordinary bolt
H
High tension bolt
Square drive size
MT Tightening torque (Maximum)
Weight*
(According to EPTA-Procedure 01/2014)
kg
Switching ON
Switching OFF
Disconnect the battery
Clockwise rotation
Counterclockwise rotation
Pilot lamp
Socket
Switch panel
Battery level indicator
switch
Battery level indicator
lamp
Hook
Screw
Groove
7
* Depending on attached battery. The heaviest weight is
measured with BSL36B18 (sold separately).
Battery
Remaining battery indicator switch
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 3 seconds.

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 151.
Standard accessories are subject to change without notice.
APPLICATIONS
Tightening and loosening of all types of bolts and nuts, used
for securing structural items
SPECIFICATIONS
The specifi cations of this machine are listed in the Table on
page 151.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
CAUTION
Do not use the electrical cord if damaged. Have it
repaired immediately.
2. Insert the battery into the charger.
Firmly insert the battery into the charger.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See Table 1)
English