Ironside IR 2000i S Manual De Uso página 27

7 Operation
NOTE: The Overload Alarm may come on for a few seconds when first using
electrical devices that require a large starting current, such as a compressor, pump,
or refrigerator. This is normal behavior it is not a malfunction.
Low Oil Alarm (Red)
When the engine oil falls below the required level the Low Oil Alarm will come on
and the engine will stop automatically. The engine will not restart until oil is added
to the unit to bring it up to the appropriate level.
NOTE: When starting the unit, if the Low Oil Alarm light flickers and the engine will
not start, you will need to add engine oil before attempting to restart the engine.
NOTE: Generator should only be operated on a level surface. DO NOT operate
the generator on loose ground or obvious inclines. The low oil shutdown feature
may be prematurely activated in these cases causing the engine to not start.
Off / Run / Choke switch
The Engine Switch controls the ignition switch. The switch must be in the "I"
position to start the generator. Switching to the "O" position stops the engine and
will not allow the engine to be restarted.
USB Outlets
The 5 VDC, 1/2.1 Amp USB outlet allows charcing of compatible electronic
devices.
Off / Run / Choke switch
The Off / Run / Choke switch controls the flow of gasoline from the fuel tank to the
carburetor. The switch should be in the "I" position when starting and operating the
27