Peg-Perego PRIMO VIAGGIO SL Instrucciones De Uso página 19

Instructions for in-vehicle use
1 1• Fit the car seat with the child seated inside,
remembering to secure the child with the harness.
1 2• Fully lower the handlebar of the car seat (point 8 -
position A).
Slide the vehicle seatbelt into the two guides on the car
seat handlebar and buckle it, ensuring the seatbelt is
taut, as shown in the figure.
1 3• Take hold of the vehicle seatbelt again and pass it
behind the backrest of the car seat, inserting it into the
rear guides as shown in the figure.
Tighten the seatbelt.
Removing the soft cover
To remove the car seat cover:
• remove the hood:
• press the red button on the crotch strap buckle to
release the harness.
1 4• Remove the booster cushion, if present (Fig. a), and
unfasten the elastic bands from under the handlebar
(Fig. b).
1 5• Remove the shoulder pads (Fig. a);
• Remove the straps from the backrest (Fig. b);
To remove the crotch strap, slip it through the opening
in the soft cover, lifting it as shown in the figure (Fig. c).
1 6• Slide off the headrest cover from the bottom first and
then, carefully, over the two sides;
BE CAREFUL NOT TO BREAK POLYSTYRENE (EPS)
PARTS.
All manuals and user guides at all-guides.com
Remove the soft cover in sequence, as shown in the
Brush the fabric parts to remove dust.
• Machine wash at a maximum of 30°C with a delicate
• Do not use chlorine bleach.
• Do not iron.
• Do not dry clean.
Do not remove stains with solvents.
• Do not tumble dry.
• To reposition the car seat cover:
17• slide the soft cover on in sequence, as shown in the
• To slide on the headrest cover, start from the two sides
• Insert the crotch strap through the opening in the soft
18• Reposition the booster cushion (Fig. a) and fasten the
19
figure.
Maintenance of the padding
wash setting and short spin cycle.
°
30
Replacing the soft cover
figure:
- slide the cover on from the top
- first carefully insert the sides of the headrest
- then slide the soft cover over the bottom of the headrest.
and then slide on the bottom (Fig. a);
cover (Fig. b) and slip it through the crotch strap cover
(Fig. c).
hood's elastic bands behind the handlebar (Fig. b).