Behringer WASP DELUXE Guia De Inicio Rapido página 18

18
WASP DELUXE
WASP DELUXE Controls
Step 2: Controls
(EN)
KEYBOARD Section
BEND knob shifts the keyboard pitch up (clockwise) or
(1)
down (counterclockwise).
TUNE knob allows fine adjustment of the keyboard pitch.
(2)
GLIDE controls the rate of change from one note to the
(3)
other. Turning the knob clockwise slows down the shift to
the next pitch.
OSCILLATORS Section
FT knob for the upper oscillator sets the oscillator's pitch.
(4)
WIDTH % knob controls the width of the
(5)
oscillator's sound.
WAVEFORM knob controls the shape of the waveform
(6)
for the upper oscillator. In the OFF setting, the waveform is
left as an unaltered sine wave.
The second-from-left setting imposes a "sawtooth"
waveform, while the next setting over creates a "square"
waveform. The ENH setting acts as an enhancer to add
punch, bit and clarity to the oscillator's tone.
FT knob for the lower oscillator sets the oscillator's pitch.
(7)
PITCH knob adjusts the pitch of the second oscillator
(8)
against the pitch of the upper oscillator to create
modulation effects.
WAVEFORM knob controls the shape of the waveform
(9)
for the lower oscillator. In the OFF setting, the waveform
is left as an unaltered sine wave. The second-from-left
setting imposes a "sawtooth" waveform, while the next
setting over creates a "square" waveform. The ENH setting
acts as an enhancer to add punch, bit and clarity to the
oscillator's tone.
MIX section controls the relative blend of the upper and
(10)
lower oscillator (OSC 1/OSC 2 knobs).
EXT. knob allows you to blend in audio signals from the
(11)
EXT. AUDIO jack with the oscillator signals.
CONTROL OSC. Section
This section offers an oscillator that does not produce sound itself,
but which can be used to control the primary oscillators and
the filter.
NOISE signal knob produces white noise that can be mixed
(12)
in to create percussion sounds.
FREQUENCY knob adjusts the speed of the
(13)
control oscillator.
PITCH MOD. varies the pitch difference between
(14)
the primary oscillators to create additional
modulation effects.
WAVEFORM switch offers six different settings:
(15)
sine was, rising sawtooth, falling sawtooth, square wave,
NOISE and RND. (random).
FILTER Section
FREQ. knob sets the filter cutoff frequency.
(16)
Q knob controls the filter width (for bandpass and notch
(17)
filter) or the filter slope (hi- and lo-pass filters).
FILTER knob offers four filter options: LO (lo-pass),
(18)
BAND (bandpass), NOTCH and HI (hi-pass).
ENVELOPE GENERATORS Section
This section has two sub-sections: VCA ENV. (controls the
envelope for the oscillators) and CONTROL ENV. (which controls
the filter envelopes).
VCA ENV.
ATTACK knob controls the speed of the note onset.
(19)
DECAY knob controls how quickly the note volume
(20)
decays while the finger remains on the keyboard and
then controls the fading out of the note after the finger
is removed from the keyboard.
SUSTAIN LEVEL/REPEAT knob controls the baseline
(21)
volume of the note while the finger remains on
the keyboard. When set full counter-clockwise,
the note repeats and the ATTACK and DECAY knobs then
control the speed of the repeat.
HOLD switch sustains the note indefinitely at the point
(22)
of the envelope when the switch is activated.