Setting The Midi Channel - Behringer WASP DELUXE Guia De Inicio Rapido

8. Securely connect the 16-pin end P2 of the supplied
adapter cable to your power supply, and double check
all connections are correct.
9. Securely install the WASP DELUXE Synthesizer into your
Eurorack, using 8 screws in the front panel.
10. Perform a full test and safety test before using the
WASP DELUXE.
11. The 3.5 mm MAIN OUT connector on the top panel is
used instead of the ." rear outputs which are no
longer present.

Setting the MIDI Channel

Once installed in a Eurorack, the MIDI channel number
is automatically set to channel 1 (as the MIDI switches are no
longer present.)
The MIDI channel can be changed using MIDI OX or a similar MIDI
utility on your computer to send MIDI SysEx commands directly
to the WASP DELUXE via the USB MIDI connection. Here is a brief
guide to the procedure (see the MIDI SysEx pages in this manual
for the actual SysEx codes sent to the WASP DELUXE):
1. Disable the MIDI Channel Switches by sending
the appropriate SysEx command.
2. Change the MIDI Channel by sending
the appropriate SysEx command.
49
Quick Start Guide