Operating Instructions; Product Description; Removing The Transport Bolts; Product Usage - Kunft KWM5316 Manual De Instrucciones

2. OPERATING INSTRUCTIONS

2.1. Product Description

Water supply hose
Detergent dispenser
Door
Note!
• The product line chart is for reference only, please refer to real
product a standard.
Accessories
Transport Supply hose Supply hose
hole plug cold water hot water
(optional)

2.2. Product usage

Installation area

Warning!
• Stability is important to prevent the washing
machine from moving!
• Make sure the washing machine does not stand on
the power cord.
Before installing the washing machine, the location characterized as
follows must be selected:
Top cover
Control Panel
Power supply cord
Drum
Service filter
Drain hose
Drain hose Owner's
support manual
(optional)
12
washing machine
1. Rigid, dry, and levelled surface
2. Avoid direct sunlight
3. Sufficient ventilation
4. Room temperature above 0° C
5. Keep far away from heat sources
Unpacking the washing machine
Warning!
• Packaging material (e.g. films, Styrofoam) can be
dangerous for children.
• There is a risk of suffocation! Keep all packaging
far away from children.
1. Remove the cardboard box and Styrofoam
packing.
2. Lift the washing machine and remove the base packing. Make
sure the small triangle foam is removed with the bottom one
together. If not, lay the washing machine down on its side, then
remove the small foam from the unit bottom manually.
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the inlet hose from the drum.

Removing the transport bolts

Warning!
• You must remove the transport bolts from the back of the washing
machine before using it.
• You will need the transport bolts again if you move the product, so
make sure you keep them in a safe place.
Please take the following steps to remove the
bolts:
1. Loosen the 4 bolts with a spanner and then
remove them.
2. Plug the holes with transport hole plugs.
3. Keep the transport bolts for future use.

Levelling the washing machine

Warning!
• The lock nuts on all four feet must be screwed tightly against the
housing.
1. Check if the legs are closely attached to the cabinet. If not,
please turn them to their original positions and tighten the nuts.
2. Loosen the lock nut by turning the feet until they are in close
contacts with the floor.
EN
KWM5316
13