Metria M51 Manual De Instrucciones página 3

METRIA M51 Benchtop Conductivity/TDS Meter
Display
The METRIA M51 Conductivity/TDS meter is equipped with an easy-read LCD display that used to show the measured values and mode
icons. The following table describes the function of each icon.
INDEX:
Measurement mode icon:
Indicates the meter is in the measurement
mode.
Calibration mode icon:
Indicates the meter is in the calibration mode.
Setup mode icon:
Indicates the meter is in the setting mode.
Keypad
The meter has a succinct membrane keypad, names and symbols describe the each function key controls.
KEY
MEAS|
MODE
CAL|
°C


ENTER
FUNCTION
• Switches the meter ON/OFF.
• Locks the measured value, press the key again to resume measuring.
• Exits the calibration or setting and returns to measurement.
• Toggles between conductivity and TDS measurement modes.
• Starts calibration.
• Enters the setup menu (Press and hold the key for 3 seconds).
• Sets the temperature.
• Increase the setting value.
• Decrease the setting value.
• Confirms the calibration, settings or displayed options.
Hold icon:
Indicates the measuring value has been locked.
Automatic Temperature Compensation:
Indicates the temperature compensation is
enabled.
2