Product Features - 2LS Tools VEGA Manual Original

All manuals and user guides at all-guides.com
OBJ_BUCH-1618-001.book Page 19 Thursday, February 16, 2012 2:01 PM
Digital Laser Rangefinder
Output voltage
Charging current
Protection class
A) The operating range increases the better the laser light is reflected from the surface of the target (dispersive, not reflective) and
the brighter the laser point is with respect to the ambient brightness (indoors, twilight). Under unfavofurable conditions (e. g., when
measuring outdoors with intense sunlight), it may be necessary to use a laser target plate.
B) For measurements from the rear measuring-tool edge. In unfavourable conditions (e. g. at intense sunlight or an insufficiently
reflecting surface), the maximum deviation is
must be taken into account.
C) For measurements with the rear side of the unit as reference, the max. measuring range is
D) After calibration at 0 ° and 90 ° with an additional grade error of
E) In the continuous measurement function, the maximum operating temperature is +40 °C.
F) at 25 °C
G) For a new and charged battery without display illumination and tone signal.
Please observe the article number on the type plate of your battery charger. The trade names of individual battery chargers may
vary.
Please observe the article number on the type plate of your measuring tool. The trade names of the individual measuring tools may
vary.
The measuring tool can be clearly identified with the serial number 18 on the type plate.

Product Features

The numbering of the product features shown refers
to the illustration of the measuring tool on the graphic
page.
1 Display
2 Measuring button
3 Button for grade measurement/calibration **
4 Button for function mode/basic settings **
5 Minus button
6 Button for result/timer function **
7 Button for measured-value list/storage of con-
stant **
8 Button for clearing the internal memory/
On/Off **
9 Positioning pin
10 Button for selection of the reference level
11 Plus button
12 Button for length, area and volume measurement
13 Charge socket cover
14 Socket for charge connector
15 Fixture for carrying strap
16 Laser beam outlet
17 Reception lens
18 Serial number
19 1/4" thread
20 Laser warning label
21 Charge connector
22 Battery charger
2 609 140 906 • 16.2.12
±
10 mm per 80 m. In favourable conditions, a deviation influence of
±
0.01 ° /degree to 45 ° (max.).
23 Protective pouch
** Keep button pressed to call up the extended func-
tions.
Display Elements
a Measured-value lines
b "ERROR" indication
c Result line
d Digital vial/position of measured-value list entry
e Measured-value list indicator
f Measuring functions
Length measurement
Area/surface measurement
Volume measurement
Continuous measurement
Indirect height measurement
1
1
Double indirect height measurement
2
Indirect length measurement
1
Timer function
Wall-surface measurement
Grade measurement
g Battery charge-control indicator
h Laser, switched on
i Measurement reference level
k Temperature warning
VEGA
5.0 V
500 mA
/ II
±
0.05 mm/m
±
60 °
English | 19