Maintenance And Service; Maintenance And Cleaning - 2LS Tools VEGA Manual Original

All manuals and user guides at all-guides.com
OBJ_BUCH-1618-001.book Page 26 Thursday, February 16, 2012 2:01 PM
Cause Corrective Measure
The measuring tool was Repeat the calibration
moved or tilted while press- and hold the measur-
ing the button. ing tool in place while
pressing the button.
Battery charge-control indicator (g), tempera-
ture warning (k) and "ERROR" indication in the
display
Temperature of the measur- Wait until the charge-
ing tool not within the allowa- temperature range is
ble charge-temperature reached.
range
Battery charge-control indicator (g) and
"ERROR" indication in the display
Battery charging voltage not Check if the plug-in
correct connection has been
established correctly
and if the battery
charger is operating
properly. When the
unit symbol is flashing,
the battery is defective
and must be replaced
by a 2LS after-sales
service.
Battery charge-control indicator (g) and clock
symbol f in the display
Charge duration clearly too Only use the original
long, as charging current too 2LS charger.
low.
Measuring result not plausible
The target surface does not Cover off the target
reflect correctly (e.g. water, surface
glass).
The laser beam outlet 16 or Make sure that the la-
the reception lens 17 are ser beam outlet 16 or
covered. the reception lens 17
are unobstructed
Wrong reference level set Select reference level
that corresponds to
measurement
Obstruction in path of laser Laser point must be
beam completely on target
surface.
26 | English
Cause Corrective Measure
The indication remains unchanged or the
measuring tool reacts unexpected after press-
ing a button
Software error Press the measuring
button 2 and the but-
ton for clearing the in-
ternal memory /
On/Off 8 to reset the
software.
The measuring tool monitors the cor-
rect function for each measurement.
When a defect is determined, only the
symbol shown aside flashes in the dis-
play. In this case, or when the above
mentioned corrective measures can-
not correct an error, have the measuring tool checked
by an after-sales service agent for 2LS tools.

Maintenance and Service

Maintenance and Cleaning

Store and transport the measuring tool only in the sup-
plied protective pouch.
Keep the measuring tool clean at all times.
Do not immerse the measuring tool in water or other
fluids.
Wipe off debris using a moist and soft cloth. Do not
use any cleaning agents or solvents.
Maintain the reception lens 17 in particular, with the
same care as required for eye glasses or the lens of a
camera.
If the measuring tool should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an authorized service centre.
Do not open the measuring tool yourself.
In all correspondence and spare parts orders, please
always include the 10-digit article number given on
the type plate of the measuring tool.
In case of repairs, send in the measuring tool packed
in its protective pouch 23.
2 609 140 906 • 16.2.12