Lavorwash MAJOR Manual De Instrucciones página 23

2) Press the main switch situated on the control
panel to the ( I ) ON ⑩ position -for working
on mains power
or
( II ) ON - for working on battery
IMPORTANT: the machine is battery ope-
rated with either the plug attached to the
electrical mains or the machine operated
with the plug disconnected from the electri-
cal mains.
3) Press the BOILER ON button situated on the
control panel to ( I ) ⑪.
6) If the display show H2O , it means that the-
re is no water in the tank. Fill the tank (see
"Filling the tanks with water and detergent")
> TO SPRAY DETERGENT
To spray and mix the detergent with steam:
- Press button ⑰ on the pistol grip.
.> Machine stop (at end of work)
At the end of the work shift, stop the machine
in the following way:
1) Press boiler switch button to (0) OFF ⑪
2) Press main switch to (0) OFF ⑩.
3) Unplug the machine from the electrical po-
wer supply.
Boiler steam discharge
Follow the instructions below:
- A few minutes before the end of the work
shift, turn off the boiler by pressing the BOI-
LER START luminous green push-button,
continuing to use the steam gun until the
pressure gauge indicates a value of 0-1 bar;
see fig. F (Optional)
Follow the instructions below:
- Carefully open the boiler drain cock, situated
on the machine right side and drain all
the water from the boiler into a suitable
container;
WARNING: Danger from hot steam.
IMPORTANT: Should it be necessary for
any reason to de-activate the machine quic-
kly, place the main switch on the control pa-
nel to the OFF position.
• WARNING:
• V15 While the machine is functioning, it
is strictly forbidden to remove safety devices
set by the Manufacturer for the purpose of
protecting the operator against incidents.
- Only skilled and qualified operators must
use the machine.
- Avoid aiming the steam lance towards
personnel or delicate objects such as plastic,
crystal or other materials which may melt or
deteriorate with contact to steam at 180°C.
- Never leave the machine unattended.
- Always remove the power supply from the
machine before filling the tanks.
- We recommend the use of demineralized
water.
CARE AND MAINTENANCE
SCHEDULED MAINTENANCE PLAN
Visit website and download the scheduled
maintenance plan.
IMPORTANT: Before doing any work
on the cleaner, discharge the pressure
and disconnect the electricity and water
supplies.
SEE ROUTINE MAINTENANCE TABLE
• WARNING
Before any maintenance or replacement
activity, remember to:
- stop the machine (MAIN SWITCH turned to
OFF)
- unplug it.
• K1 Maintenance, replacement or servicing
activities described in this handbook must
be entrusted only to skilled operators
familiar with the technology used on the
machine.
• K2 Consult qualified personnel at the
manufacturer or sales outlet for any
adjustment, tuning or replacement actions
not included in this manual.
23
EN