Section 3: Diagrams; Circuit Boards Location; Schematic Diagrams Information - Sony KLV-40W300A Manual Del Usuario

Ocultar thumbs Ver también para KLV-40W300A:
Tabla de contenido

Publicidad

3-1. CIRCUIT BOARDS LOCATION

DF3 (KLV-46W300A)
DF5 (KLV-52W300A)
HW2
3-2. PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS INFORMATION
All capacitors are in μF unless otherwise noted. pF : μμF 50WV or
less are not indicated except for electrolytics and tantalums.
All electrolytics are in 50V unless otherwise specifi ed.
All resistors are in ohms. kΩ=1000Ω, MΩ=1000kΩ
Indication of resistance, which does not have one for rating
electrical power, is as follows:
1
1
/
W in resistance,
/
W and
4
10
: nonfl ammable resistor
: fusible resistor
: internal component
: panel designation and adjustment for repair
: earth ground
: earth-chassis
All variable and adjustable resistors have characteristic curve B,
unless otherwise noted.
Readings are taken with a color-bar signal input.
Readings are taken with a 10MΩ digital multimeter.
Voltages are DC with respect to ground unless otherwise noted.
Voltage variations may be noted due to normal production
tolerances.
KLV-40W300A/46W300A/52W300A

SECTION 3: DIAGRAMS

FB1
TUU2
AU
Pitch : 5mm
Rating electrical power :
1
/
W in chip resistance.
16
HW1
All voltages are in V.
S : Measurement impossibility.
: B+line.
: B-line. (Actual measured value may be different).
: signal path. (RF)
Circled numbers are waveform references.
1
/
W
4
The components identifi ed by shading and
only with part number specifi ed.
The symbol
indicates a fast operating fuse and is displayed on the component
side of the board. Replace only with fuse of the same rating as marked.
Les composants identifi es per un trame et une marque
securite. Ne les remplacer que par une piece portant le numero specifi e.
Le symbole
indique une fusible a action rapide. Doit etre remplace par une
fusible de meme yaleur, comme maque.
NOTE: The components identifi ed by a red outline and a mark contain confi dential
information. Specifi c instructions must be adhered to whenever these components
are repaired and/or replaced.
See Appendix A: Encryption Key Components in the back of this manual.
KLV-40W300A/46W300A/52W300A
DF1 (KLV-40W300A)
DF2 (KLV-46W300A)
DF4 (KLV-52W300A)
GF1 (KLV-40W300A/
KLV-46W300A)
GF2 (KLV-52W300A)
HW3
!
symbol are critical for safety. Replace
!
sont critiques pour la
22

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Klv-46w300aKlv-52w300aRm-yd017

Tabla de contenido