CAUTION
When connecting to water supply mains, local
regulations of your municipal water company
must be observed. In some areas connecting
directly to public drinking water supply may
require a backfl ow prevention device. This is
to ensure that there is no feedback of chemi-
cals into the water supply. Use a water fi lter to
avoid potential damage from dirt in the water
supply.
■
Garden hose must be at least 5/8 inch
diameter.
■
Flow rate of water supply must not fall below
2.5 GPM (gallons per minute)
Description
A
Knob 1/4"
B
1/4" X 1-1/2"
Bolt
C
1/4" X 2-1/2"
Bolt
D
Wand Holder
E
Nozzle Holder
F
High Pressure
Hose
WATER SUPPLY
(Cold Water Only)
ASSEMBLY INSTRUCTIONS
Hardware (included)
Purpose
Joint Assembly
Joint Assembly
Wand Holder Assembly
Wand Holder Assembly
Nozzle Holder Assembly
Spray Gun Assembly
■
Flow rate can be determined by running the
water for one minute into an empty 5-gallon
container.
■
The water supply temperature must not ex-
ceed 104°F/40°C.
■
Never use the pressure washer to draw in
water contaminated with solvents, e.g. paint
thinners, gasoline, oil, etc.
■
Always prevent debris from being drawn into
the unit by using a clean water source. Use
additional water fi lter.
■
Do not operate pressure washer without the
water turned on.
Illustration
Qty
2
1
1
1
1
1
English 5