Publicidad
(I) INSTALLING THE FAUCET:
• Remove faucet body from the carton.
• Apply putty or other sealant to the bottom surface of the
fitting.
• Install faucet through the mounting holes.
• Finger tighten the synthetic locknuts over the supply
stems.
• Align faucet exactly as desired and securely tighten
synthetic locknuts by hand.
• Connect water supply using the supply nuts supplied.
• Romove aerator and flush both hot and cold water lines.
Reinstall aerator and check for leaks at all fittings
I
(II) INSTALLING THE DRAIN:
• Whether a new installation or replacing an existing
darin, be certain that all mounting surfaces are clean
and dry.
• For ABS drains, use NO oil base compounds!
• Unscrew flange and remove washer from drain assembly.
• If necessary, apply putty or sealant to bowl under the
washer to assure seal.
• With the nut, follower, and mac washer at their lowest
position on the threads, install through the bottom of
the bowl and screw the top flange into the drain body
until tight. If the drain has a pop-up, position the side
port of the drain body toward the back wall.
• Secure the drain body by advancing the nut, follower, and
the mac washer up the drain body threads. Tighten until
the top flange is in close proximity to the lavatory. DO NOT
OVER TIGHTEN. OVERTIGHTENING MAY DAMAGE
LAVATORY OR SEALS!
II
Publicidad
