Installation Procedure; Removing The Mounting Plate; Finding The Wall Studs; Possible Wall Stud Configurations - Bosch HMV 3051 U Instrucciones De Instalación

Installation procedure

Removing the mounting
plate

Finding the wall studs

Possible wall stud configurations

10
Note: To avoid possible damage to the work surface or to the bottom of the
appliance, cover the worksurface.
1. Remove any remaining contents from the microwave oven cavity.
2. Remove the screws from the mounting plate.
This plate will be used as the rear wall template and for mounting.
3. Reinstall the screws into the holes where they were removed.
Note: To avoid damage to the microwave oven, do not grip or use the door or door
handle while the microwave oven is being handled.
Note: The microwave must be connected to at least one wall stud. If no wall studs
exist within the cabinet opening, do not install the microwave oven.
1. Locate the edges of the wall studs within the cabinet opening by using:
a stud finder or
D
a hammer (tapping lightly across the mounting surface to find a solid sound).
D
2. Place a mark halfway between the edges and draw a line down the center of the
studs (See possible wall studs configuration)
These depictions show examples of preferred installation configurations with the
mounting plate.
Note: Care must be taken when drilling holes. Electrical wires may be concealed
behind the wall covering and contact with them could result in electrical shock.