Abicor Binzel iCAT WH Instructivo De Servicio página 41

iCAT WH
6.6 Attaching the ROBO WH torch neck
1
1 ROBO WH torch neck
2
Hand lever
Fig. 11 Attaching the ROBO WH torch neck
NOTICE
• Do not move the hand lever position during the change procedure! This will result in
malfunctions. The open knife will cause the pre-tensioned welding wire to expand and to
become cut off when actuated next. These wire pieces will block the locking mechanism
and inevitably lead to failures of the entire system!
1 Insert hand lever (2) through the sealing lips of the clamping bracket (4).
2 Move hand lever (2) forward toward the torch neck (1) through the pressure point as far as
it will go.
3 Insert torch neck into changeable body as far as it will go.
4 Move hand lever (2) through the pressure point as far as it will go and take it out after
locking.
7 Operation
Due to the fact that the iCAT WH is integrated into the welding process of the torch, the
operating steps are performed after the respective torch has been put into operation. Please
observe the operating instructions of the respective ROBO WH welding torches.
5
3 iCAT WH-ROBO WH
4
Clamping bracket (in
changeable body)
2
3
4
5 Changeable body
7 Operation
EN - 19